Deep Cleaning Bathroom Tile & Grout in Beckenham
Recently I was asked to renovate the tile and grout of this windowless bathroom in a Beckenham flat which was not looking its best. The Ceramic tiles had become dull due to a build up of Limescale and the grout had become stained from shampoo dyes and mould.
Deep Cleaning Bathroom Tile and Grout
My first action was to apply a liberal amount of Tile Dr Oxy-Gel which is a strong alkaline tile and grout cleaning product that comes in a gel form. Being a gel it’s able to sticks to vertical surfaces for longer allowing it to break down the Limescale and soap residue that had taken up residence. Once it had been left to dwell for around thirty minutes, it was scrubbed off with water and a pan scrapper and then dried with a micro cloth. You can use this process with glazed ceramic tiles like these but for natural stone I would have used a different approach.
I then sprayed Tile Doctor Duo Clean, which is a grout cleaner and mould remover, onto the grout lines. I left the grout with the Duo Clean on it for about ten minutes before scrubbing and rinsing off with water.
The process was repeated where needed until I was happy that the tile and grout were as clean as possible however to really give the bathroom a fresh look I decided to completely renovate the grout with the application of a Grout Colourant.
Grout Colouring Bathroom Wall Tiles
There are ten colours to choose from in the Tile Doctor range of Grout Colourant’s and in this case I felt the best outcome would be to use a White colourant to match the tiles and restore the original look of the bathroom; the customer however wanted a grout colour that would provide a contrast against the white tiles, so in the end we opted for a light grey colour.
The colourant is easily applied directly to the grout and in this case I waited for the tiles to dry before applying two coats with the aid of a small brush making sure to remove any excess that comes into contact with the tile.
I finished the renovation by cutting out the original mastic sealant from around the bath and replacing with a new mould resistant silicone in white to match the bathtub.
Bathroom Tile Renovation in Kent
Bathroom and Kitchen Tile Refresh in Greenhithe, Kent
This customer from Greenhithe, Kent contacted Tile Doctor to have the tiles in her bathroom refreshed; the tiles which were looking tired and poor ventilation had caused her grouting to go black. This is not uncommon in the UK due to the inclement weather and tighter building regulations designed to promote draught proofing and insulation leaving moisture trapped in the house.
Bathroom Tile and Grout Cleaning
I first started off by cleaning all the tiles down with a weak solution of Tile Doctor Pro-Clean which is a multi-purpose cleaning product; there wasn’t a large amount of grime on the tiles and just general wear and tear on the floor with Limescale and water marks on the wall tiles. I then set about cleaning up the blackened grout with a steam cleaner followed by Tile Doctor Grout Colourant Pre-Treat cleaner, an acid based cleaner that etches the grout in order for it to accept the grout colourant. After cleaning and etching the grout joints they were rinsed down with plenty of water to remove any trace of chemical and then dried them out to receive the grout colourant.
 |
 |
Removing Grout Haze from Quarry Tiles
The grouting to the wall tiling in the bathroom was white, and the customer wanted it looking the same only fresher, so white grout colourant was applied. The grouting to the kitchen floor was originally a sand colour, but the customer wanted something more contrasting this time, so natural grey was used. Once the grout colourant was applied, it was allowed to set for 30mins before the edges were cleaned up. I finished by renewing the mastic sealant around the edges of the bath.
 |
 |
The job took a day and as you can see from the photographs made a huge difference to the bathroom and kitchen, needless to say the customer was really happy with the end result.